|
We are looking at the importance of correlation between Simulated antenna radiation pattern and actual OTA (over the Air) measurement to get confidence on a MilliBox test setup.
|
|
Keith Benson, Director, RF/MW Amplifier & Phased Array IC Products at Analog Devices, talks with Pat Hindle about the trends in the IC and component markets including the various tradeoffs made…
|
|
Learn about modeling and simulating the single chip Otava beamformer IC (BFIC), a wideband 8-channel transmitter and receiver operating at mmWave frequencies.
Based on actual measurements, the…
|
|
Learn how fast analysis techniques enable design space exploration and antenna optimization for PCB antenna design following MATLAB and Antenna Toolbox design workflow. By including the estimation of…
|
|
Learn how MATLAB and Simulink can be used to design RF transceivers with integrated antenna array for wideband communication systems, radar, and smart location devices, where a combination of…
|
|
Richardson RFPD/NXP demonstrates their 5G mmWave phased array setup at EuMW 2022 in Milan.
|
|
RF Lambda reviews their new products including high power, broad band amplifiers at EuMW 2022 in Milan.
|
|
Eric Bonelli, Application Engineer at Wolfspeed, demonstrates a 200 W, dual transistor, S-Band pallet with about 44% efficiency at 2.5 GHz and about 36 dB large signal gain.
|
|
Greg Bonaguide, Applications Engineer at R&S, demonstrates a D-Band (110-170 GHz) solution showing measurement of IMD on an amplifier.
|
|
Ruben Zarrabi from Richardson RFPD and Bernie Gobeil from SignalCraft Technologies discuss a new family high performance frequency converters covering 24 to 44 GHz.
|
|
At EuMW 2021, Steve Dudkiewicz, Vice President, Marketing & Business Development, demonstrated the MMW-STUDIO active load pull solution in partnership with Vertigo Technologies.
MMW-STUDIO…
|
|
IVCAD, the industry leading device characterization software platform brought to you by Maury Microwave and AMCAD Engineering, empowers powerful post-measurement data analysis within the software…
|
|
Microwave Journal Media Director, Pat Hindle, and guest co-host Yasmine King, GM of A&D at ADI, discuss the April Amplifier and Oscillator themed issue technical articles, industry news and EuMW…
|
|
Vector receiver load pull, also referred to as real-time load pull, has become the preferred load pull methodology of the 2010s and 2020s. Vector receiver load pull replaces a traditional scalar…
|
|
During the initial stages of device technology development, timely feedback to device development engineers is important to accelerate the development process. Quickly and accurately benchmarking…
|
|
Performing device characterization measurements at millimeter-wave and sub-THz frequencies can be challenging for several reasons. First, it’s difficult to achieve accurate and repeatable…
|